Search found 32 matches

by Clutch
Mon Sep 24, 2012 11:43 pm
Forum: Technical Discussion
Topic: Speedometer cable
Replies: 0
Views: 4514

Speedometer cable

I have a question see if any one can help me .. Is the OEM speedometer cable considered a 12mm top nut cable? Any help is appreciated thx
by Clutch
Sat Jan 07, 2012 1:37 pm
Forum: Technical Discussion
Topic: Carb #3 no suction
Replies: 13
Views: 6911

Re: Carb #3 no suction

Well turns out it is a bad coil.I will be ordering one ASAP.. I will post an update when i install them thx once again Volker_p
by Clutch
Thu Jan 05, 2012 1:00 pm
Forum: Technical Discussion
Topic: Carb #3 no suction
Replies: 13
Views: 6911

Re: Carb #3 no suction

I will do the following procedures ,question to measure the pulsar gap can I use a regular metal feeler gauge or does it have to be a non magnetic feeler gauge?
by Clutch
Wed Jan 04, 2012 5:28 pm
Forum: Technical Discussion
Topic: Carb #3 no suction
Replies: 13
Views: 6911

Re: Carb #3 no suction

Update: I swapped spark plug 3&4 still no go. Then I checked the spark on all 4 plugs spark plugs 2 and 3 have a stronger spark then 1 and 4 ,so I take it that I have one weak coil. Explains the puffy carbon build up on those plugs. Could that possibly be the reason that it bogs down? I cleaned ...
by Clutch
Wed Jan 04, 2012 9:31 am
Forum: Technical Discussion
Topic: Carb #3 no suction
Replies: 13
Views: 6911

Re: Carb #3 no suction

I'll swap out the plugs today and check for air leaks between the engine and the carbs.The choke flap and slider do open with the other carbs.
The circular diaphragms are on the side of each carb correct?
by Clutch
Tue Jan 03, 2012 8:05 am
Forum: Technical Discussion
Topic: Carb #3 no suction
Replies: 13
Views: 6911

Re: Carb #3 no suction

Yes I did swap spark plug cable 2 & 3 and with the carb filter off I put my palm on the back of the carb and there's no suction. Its like I'm running on three cylinders only.
by Clutch
Mon Jan 02, 2012 8:15 pm
Forum: Technical Discussion
Topic: Carb #3 no suction
Replies: 13
Views: 6911

Re: Carb #3 no suction

Yes I check and adjusted the valves to specs.. Also did a compression test wet & Dry..
by Clutch
Mon Jan 02, 2012 5:52 pm
Forum: Technical Discussion
Topic: Carb #3 no suction
Replies: 13
Views: 6911

Carb #3 no suction

I need help for some reason carb #3 has no suction?So exhaust #3 does not heat up at all? Any help will be appreciated.. Thx
by Clutch
Fri Aug 26, 2011 12:30 pm
Forum: Technical Discussion
Topic: One cylinder running rich?
Replies: 11
Views: 7693

Re: One cylinder running rich?

I will check the accelerator pump & carb synchronization this weekend. I will post an update later during the week . thx again
by Clutch
Thu Aug 25, 2011 4:38 pm
Forum: Technical Discussion
Topic: One cylinder running rich?
Replies: 11
Views: 7693

Re: One cylinder running rich?

I re-adjusted my valves according to the service manual ,bike fires up great and sounds the way it should sound ,then when it did before... Now I will have to address the carb issue , cause it has some hesitation under load when going on the fwy.. I had to rev the accelerator back & forth to get...
by Clutch
Thu Aug 25, 2011 4:24 pm
Forum: Technical Discussion
Topic: One cylinder running rich?
Replies: 11
Views: 7693

Re: One cylinder running rich?

cb650 wrote:Got your post and the original combined in my head. :lol:

Yea I kinda figured you did :D
by Clutch
Mon Aug 15, 2011 9:55 am
Forum: Technical Discussion
Topic: One cylinder running rich?
Replies: 11
Views: 7693

Re: One cylinder running rich?

cb650 wrote:90 and 95 jets? in 82 they should be 118. What do your carbs look like? I suspect you have a older motor.
U will need to get the plug issue fixed.

My bike is a 1979 so stock I believe are 90's so I only went up two sizes up cause of the pod filters 2&1 exhaust with baffle..
by Clutch
Mon Aug 15, 2011 9:52 am
Forum: Technical Discussion
Topic: One cylinder running rich?
Replies: 11
Views: 7693

Re: One cylinder running rich?

I did the spark plug wire & spark plug swap and still cylinder #3 is @ a lower temp then 1,2,& 4 .. What I will do is check my valves make sure they are adjusted properly and with the right amount of free play..
I will post the results thx VolKer_p
by Clutch
Sat Aug 13, 2011 4:42 pm
Forum: Technical Discussion
Topic: One cylinder running rich?
Replies: 11
Views: 7693

Re: One cylinder running rich?

I"m also having the same problem on cylinder #3 took the carbs down cleaned them out with carb cleaner and compressed air ..Installed carbs fired it up and exhaust on cylinder #3 is not as hot as 1,2, & 4 .. Took a look @ the plug and it was a bit wet and it has spark. Also checked the volt...
by Clutch
Wed Jul 20, 2011 11:19 am
Forum: Technical Discussion
Topic: Cam Lobe
Replies: 4
Views: 3118

Re: Cam Lobe

I really appreciate the info I'll look for the right cams 36mm .. thx

Go to advanced search