Signal Relay
Posted: Mon Oct 23, 2017 10:24 am
Hey guys, seeing if some of you may have some ideas. I am installing new signals on the 82 Hawk and have hit a snag. I bought a new electronic flasher relay to accommodate the LED signals. There are 3 wires I am seeing, a green/white, green and gray. When I bought the bike it had no signals and the wires were tucked away and zip-tied up My flasher relay is a two wire, black/red. Looking at the schematic in my Haynes manual it is showing that it is a 3 wire system, but online diagrams show me only a two wire using the green/white and gray wires. With the new relay plugged into the green/white and green I believe it keeps blowing the tail light fuse when I apply the front brake switch.
So, does anyone know which wires my new relay should plug into? The green/white wire is always receiving battery voltage with key on as I checked with my meter and I am assuming that the green is ground or a spare ground perhaps and the gray is the signal wire???
Thanks guys
So, does anyone know which wires my new relay should plug into? The green/white wire is always receiving battery voltage with key on as I checked with my meter and I am assuming that the green is ground or a spare ground perhaps and the gray is the signal wire???
Thanks guys