Quite often, people will purchase aftermarket starter solenoids for their bikes. When they arrive, many are surprised to find that they cannot simply plug them in with the existing plug. Wiring them in is simple, and only requires that you remove the individual plugs from the plastic holder, or clip the wires and crimp on new connectors.
Plug the individual connectors in as follows: "M" identifies the wire to go to the starter motor. "B" is the wire to the battery.
How to Wire a Replacement Starter Solenoid
How to Wire a Replacement Starter Solenoid
Have a problem with your CB650? Have a technical question? Click here!
My Current Bikes: 2005 HD FLHTCUI Electra Glide Ultra Classic, 2007 Yamaha Vino,
My Current Bikes: 2005 HD FLHTCUI Electra Glide Ultra Classic, 2007 Yamaha Vino,
Re: How to Wire a Replacement Starter Solenoid
Reviving an old thread, this was a life saver for me as I replaced the original solenoid with aftermarket from 4into1. How did you figure out the aftermarket starter solenoid wiring? I wiring diagram was not provided with the unit I purchased, this was the only how-to I found anywhere. Without it, I'd have been dead-in-the-water.
1982 CB650SC
Re: How to Wire a Replacement Starter Solenoid
I'm glad I could help! I learned this on the DOHC forum.
Have a problem with your CB650? Have a technical question? Click here!
My Current Bikes: 2005 HD FLHTCUI Electra Glide Ultra Classic, 2007 Yamaha Vino,
My Current Bikes: 2005 HD FLHTCUI Electra Glide Ultra Classic, 2007 Yamaha Vino,
Return to “Technical Discussion”
Who is online
Users browsing this forum: No registered users and 15 guests