I did a compression test on my bike.
Cylinder-
1. 0
2. 0
3. 0
4. 40
Any ideas how to fix this and get more compression.
Compression test
Re: Compression test
Little history on the bike might be good. As stands a total rebuild or a donor engine. Depends also what else might be wrong with it.
Did you clean the tank out?!?!?!?!
-
- Posts: 21
- Joined: Wed Mar 23, 2016 11:35 am
Re: Compression test
I took the engine apart due to leaking alot of oil when i rode it. Replaced all the gaskets in the engine and rebuilt the carbs. I had everything put back to factory settings. Cards are were tested and passed but not getting enough compression in the engine.
Sent from my SM-N920P using Tapatalk
Sent from my SM-N920P using Tapatalk
Re: Compression test
did you replace the rings too? cam and valves set right?
Did you clean the tank out?!?!?!?!
-
- Posts: 21
- Joined: Wed Mar 23, 2016 11:35 am
Re: Compression test
Yes
Sent from my SM-N920P using Tapatalk
Sent from my SM-N920P using Tapatalk
-
- Posts: 21
- Joined: Wed Mar 23, 2016 11:35 am
Re: Compression test
I dont know of any place to send it out to to get them honed
Sent from my SM-N920P using Tapatalk
Sent from my SM-N920P using Tapatalk
Re: Compression test
That probably explains it. The new rings are not seated to the old wear pattern. you can buy a cheap hone and use a drill just keep it oiled.
Did you clean the tank out?!?!?!?!
Return to “Technical Discussion”
Who is online
Users browsing this forum: No registered users and 56 guests