Stator/Brush Wiring Harness

If it's broken or just needs tweaked

Moderators: Volker_P, tidd650

User avatar
Hutch1
Posts: 64
Joined: Sat Jan 25, 2014 7:09 am
Location: Ohio

Stator/Brush Wiring Harness

Postby Hutch1 » Sun Aug 06, 2017 9:58 am

I found another suprise from the previous owner, seems that he rewired the stator/brush connector and did a poor job of it. Since the connector and terminals are in bad shape, I plan to buy the parts and rewire. There are 5 wires total, 3 yellow and one each black and white. I haven't chased the wires back, I'm guessing the 3 yellow are for the stator, the black/white wires are for the brushes.

Can anyone tell me the wire specs need?

I'm ordering the latch and connectors from vintage connections.

MP6L 6-pin Latching Set
M63 (18-14 AWG) Brass Male Spade
F63 (18-14 AWG) Brass Female Spade
Attachments
0806171045.jpg
0806171045.jpg (683.34 KiB) Viewed 3486 times
0806170941b_Burst02.jpg
0806170941b_Burst02.jpg (1.77 MiB) Viewed 3486 times
1982 CB650SC

MEHall
Posts: 403
Joined: Mon Nov 15, 2010 8:25 am
Location: Sweden

Re: Stator/Brush Wiring Harness

Postby MEHall » Sun Aug 06, 2017 11:49 am

Well one thing is to measure the inner core diameter of those wires.
When diameter is measured you must half that measurement to get the radius.
The calculation you need to do is- r x r x pi = the area of the wires, r is the radius. :wink:
Pi is aproxemately 3.14159265359 the sign is π. Hope that helps. :wink:





8)
Riding bikes? I ride where ever i want and whenever i want. :wink:

Online manual: http://cosky0.tripod.com/

User avatar
Hutch1
Posts: 64
Joined: Sat Jan 25, 2014 7:09 am
Location: Ohio

Re: Stator/Brush Wiring Harness

Postby Hutch1 » Fri Sep 08, 2017 6:46 pm

I'm finally getting to the stator output repair. Is the sequence of the yellow wires/pins in the connector critical?
1982 CB650SC


Return to “Technical Discussion”

Who is online

Users browsing this forum: No registered users and 41 guests