If it's broken or just needs tweaked
6 posts • Page 1 of 1
Loosen the screw in the green circle on the cable guide to release the cable, no need to undo the screw fully. Then unclip the cable from the pulley in the red circle. To replace the cable, first clip the nipple in to the pulley in the red circle then take up the slack in the cable and tighten the screw in the green circle on the cable guide.
You may find it easier to make a wire loop to catch the pulley if it is difficult to reach between the carbs but I never had a problem. Just wrap a piece of fine wire around something round and twist it into a loop, I also find this a good little tool for connecting choke springs when I rebuild carb racks.
Who is online
Users browsing this forum: No registered users and 23 guests