Carb Cleaning -- success
Posted: Tue Mar 06, 2018 4:10 pm
Executive summary:
Idle jet passages can be cleaned by boiling the carbs. I split my carbs and did 2 at a time. Remove everything you can. Cover with water, add a cup of Simple Green. Boil 2-3 hours.
Detail and story:
When i bought my CB650C, i noticed two of the exhaust pipes were rusty from the carb to the ground, while the other two looked nice. It raised a flag in the back of my mind but nothing i could put my finger on. Bike was hard to start, but would start. Ran on the rough side, but being new to 4 cyclinders, sound like it might be ok. Both exhausts were pushing out air, so maybe it's ok? On the road, it's a little iffy running, until you open the throttle then WOW it's smooth and powerful and made me fall in love. With a little research, i learned about the three different jets and when each is utilized. Also learned that the piano wire trick doesn't work on the idle jet passage because the jet is pressed in.
Diagnosis:
Remove the bowl and the float and you'll see three tubes coming up from the body. One has a brass jet screwed into it; ignore that one. The middle one is the idle jet. Get a can of carb cleaner, use the red spray tube but wrap the tip in duct tape until it just barely fits into the idle jet opening. The goal is to create a seal. USE SAFETY GOGGLES, don't ask me how i know. Spray. If you hear a gurgle, your jet passage is clear. If it builds pressure and the cleaner squirts back out past the duct tape, it's blocked.
Solution:
Use a kitchen pot that you don't need any more, because this will likely ruin it. Open the windows, turn on the fans. This will stink. Not rancid, terrible, but my lovely bride was not happy (I eventually transitioned to a single corded burner in the garage). Put the carbs in, cover in water completely, add a cup of Simple Green (splash it in, it's not science), turn the heat on high and let it boil for 2-3 hours. Check the pot occasionally; the water and cleaner will boil off, exposing the tops of the carbs. Top it off. When done, rinse well with water, blow out with an air gun, and apply WD40 generously. Repeat the diagnosis, repeat the boiling if needed.
The Simple Green won't corrode or attack the carbs like lemon juice might. SG helps clean faster than water alone.
Hope this helps someone!
Idle jet passages can be cleaned by boiling the carbs. I split my carbs and did 2 at a time. Remove everything you can. Cover with water, add a cup of Simple Green. Boil 2-3 hours.
Detail and story:
When i bought my CB650C, i noticed two of the exhaust pipes were rusty from the carb to the ground, while the other two looked nice. It raised a flag in the back of my mind but nothing i could put my finger on. Bike was hard to start, but would start. Ran on the rough side, but being new to 4 cyclinders, sound like it might be ok. Both exhausts were pushing out air, so maybe it's ok? On the road, it's a little iffy running, until you open the throttle then WOW it's smooth and powerful and made me fall in love. With a little research, i learned about the three different jets and when each is utilized. Also learned that the piano wire trick doesn't work on the idle jet passage because the jet is pressed in.
Diagnosis:
Remove the bowl and the float and you'll see three tubes coming up from the body. One has a brass jet screwed into it; ignore that one. The middle one is the idle jet. Get a can of carb cleaner, use the red spray tube but wrap the tip in duct tape until it just barely fits into the idle jet opening. The goal is to create a seal. USE SAFETY GOGGLES, don't ask me how i know. Spray. If you hear a gurgle, your jet passage is clear. If it builds pressure and the cleaner squirts back out past the duct tape, it's blocked.
Solution:
Use a kitchen pot that you don't need any more, because this will likely ruin it. Open the windows, turn on the fans. This will stink. Not rancid, terrible, but my lovely bride was not happy (I eventually transitioned to a single corded burner in the garage). Put the carbs in, cover in water completely, add a cup of Simple Green (splash it in, it's not science), turn the heat on high and let it boil for 2-3 hours. Check the pot occasionally; the water and cleaner will boil off, exposing the tops of the carbs. Top it off. When done, rinse well with water, blow out with an air gun, and apply WD40 generously. Repeat the diagnosis, repeat the boiling if needed.
The Simple Green won't corrode or attack the carbs like lemon juice might. SG helps clean faster than water alone.
Hope this helps someone!