Right Hand Switch

If it's broken or just needs tweaked

Moderators: Volker_P, tidd650

User avatar
Hutch1
Posts: 64
Joined: Sat Jan 25, 2014 7:09 am
Location: Ohio

Right Hand Switch

Postby Hutch1 » Tue Jan 01, 2019 9:41 am

I have been racking my brain for the past 2 days trying to figure out how to wire an aftermarket Emgo right hand switch to replace the OEM unit ('82 CB650SC), any advice would be greatly appreciated. What I've come up with is:

OEM Wire to New Switch Wire:
Start Button - Blue/White to Blue - switched hot to dimmer
Start Button - Black/Red to Black - fused hot to start button
Start Button - Black to Red - switched hot to start button???
Start Button - Yellow/Red to Black/Red - start circuit to starter relay
Engine Stop - Black to White - switched hot to kill switch???
Engine Stop - Black/White to Black/White - ignition hot to coils
On-Off Switch - n/a to Yellow/Red - not needed?
On-Off Switch - n/a to Yellow - not needed?
On-Off Switch - n/a to Black/Yellow - not needed?

Plan to use the OEM connector.
Attachments
hondaCB650SCwiring.jpg
hondaCB650SCwiring.jpg (194.3 KiB) Viewed 533 times
46-68735-wiring-diagram-emgo-universal-multi-switch-handlebar-motorcycle-dual-sport-cafe-pin-out-right.jpg
46-68735-wiring-diagram-emgo-universal-multi-switch-handlebar-motorcycle-dual-sport-cafe-pin-out-right.jpg (324.81 KiB) Viewed 533 times
1982 CB650SC

Ox Moto
Posts: 4
Joined: Mon Dec 04, 2017 8:29 am

Re: Right Hand Switch

Postby Ox Moto » Tue Jan 01, 2019 10:24 am

Use a volt meter to make sure you have the right in and out for all the buttons.
Also make sure it grounds to bars if you have new bars or chrome bars you might have to grind a bit undernieth so it makes contact on the switch ground

Sent from my Pixel 2 XL using Tapatalk


Return to “Technical Discussion”

Who is online

Users browsing this forum: Bing [Bot], Google [Bot] and 10 guests