Did a little research on the ultrasonic cleaner and seeems pretty cool. Which I had that when I started the project but it’s been so long it probably wasn’t invented yet .
I’ll post photos tomorrow but engine still isn’t in. Took the entire break to replace all the gaskets I could get to and finish polishing. Engine looks great imho. Need to research a little on the best way to install the motor. Probably just going to muscle it with a friend but who knows.
Therapy Project
-
- Posts: 27
- Joined: Sun Apr 21, 2013 11:39 am
- Location: Simi Valley, CA
-
- Posts: 27
- Joined: Sun Apr 21, 2013 11:39 am
- Location: Simi Valley, CA
-
- Posts: 27
- Joined: Sun Apr 21, 2013 11:39 am
- Location: Simi Valley, CA
Re: Therapy Project
Well, at last the motor is in. Having a little trouble getting it to seat properly on the drive but its mounted. At least I didn't scratch the frame too bad.
Going to add a little drive oil to see if I can get it to slip into place. Any suggestions on next steps? was thinking about the wiring harness but not completely sure.
Going to add a little drive oil to see if I can get it to slip into place. Any suggestions on next steps? was thinking about the wiring harness but not completely sure.
Return to “Technical Discussion”
Who is online
Users browsing this forum: No registered users and 41 guests